Ensure that the inductive charging plate is active and the center of the hand controller, which is between LED lights 3 and 4, is correctly positioned in the center of the charger.
As the controller is being charged the LED lights will flash one at a time—starting at the bottom of the controller and moving upwards towards the throttle—indicating the amount of charge accordingly.
When the last LED light at the top of the controller has stopped blinking, the controller is fully charged.
Be sure to remove the controller from the inductive plate after it’s fully charged.
Also note that, if the controller hasn’t been used in a while, it may take some time for the first blinking LED light to appear.
To check the level of charge of the hand controller, make sure that the magnet key of the board leash is NOT connected to its fitting on the back of the jetboard. Then activate the hand controller. The blinking LED lights indicate the controller’s level of charge.