Start by removing the rubber connector covers from both the battery and the board.
Use the side handles to bring the battery to the jetboard. To place the battery into its proper slot in the center of the board, hold the battery’s front and rear ends. Be sure to keep the battery level while inserting it.
Note that the battery is designed to fit securely in place and some extra pressure from your palm may be needed.
Once the battery is in place, turn all of the lock rings clockwise. Try to apply pressure with your palm or knee around each lock at a time as you turn them into place. You will hear a click sound when the lock ring is properly secured.
Once tightened, the lock rings should not be loose in any way. If you suspect the lock rings are still loose after tightening, or if you feel as though you need tools to tighten them further, do not put the board in the water. Submit a request with our Product Support team and they will assist you.