Before bringing the jetboard into the water, you can test the jetboard on land to make sure everything is working properly.
First, pair the hand controller by connecting the magnet key of the board leash into its fitting on the back of the jetboard.
Then, press the controller throttle all the way down for up to 5 seconds until the LED lights begin to flash.
When the lights go from flashing to steady, the controller is paired with the jetboard. Continue to apply pressure to the throttle. When you do this, you should hear the hum of the jetboard start.
During the dry test, the jetboard will not go into full capacity since it can’t be cooled off by the water. When the jetboard is in water, the jetboard will go into full capacity.